Roll Crushers are compression type crushers, and were once widely used in mining. They have, within the last 10 or so years, fallen into dis-favor among mining and processing companies. The probable reason is because the large mines require very large crushed product output with minimal cost, makes the roll crusher uncompetitive. The roll crushers are not nearly as productive as cone crushers, with respect to volume, and they do have a little higher maintenance associated with them. Roll crushers do, however, give a very close product size distribution, and if the ore is not too abrasive, they do not have high maintenance costs. Roll crusher is mainly used for the crushing of medium or lower-hardness mines and rocks with medium or lower rigidity in mine selection, chemicals, cement and building materials industrial production.
Roll crushers have a theoretical maximum reduction ratio of 4:1. If a 2 inch particle is fed to the roll crusher the absolute smallest size one could expect from the crusher is 1/2 inch. Roll crushers will only crush material down to a minimum particle size of about 10 Mesh (2 mm). A roll crusher crushes using compression, with two rolls rotating about a shaft, towards the gap between the rolls. The gap between the rolls is set to the size of product desired, with the realization that the largest feed particle can only be 4 times the gap dimension.
The particles are drawn into the gap between the rolls by their rotating motion and a friction angle formed between the rolls and the particle, called the nip angle. The two rolls force the particle between their rotating surface into the ever smaller gap area, and it fractures from the compressive forces presented by the rotating rolls. Some major advantages of roll crushers are they give a very fine product size distribution and they produce very little dust or fines. Rolls crushers are effectively used in minerals crushing where the ores are not too abrasive and they are also used in smaller scale production mining of more abrasive metal ores, such as gold. Coal is probably the largest user of roll crushers, currently, though. Coal plants will use roll crushers, either single roll or double roll, as primary crushers, reducing the ROM coal. Usually, these crushers will have teeth or raised forms on the face of the roll. (Roll crushers used for minerals and metal ores have smooth faced rolls.)
Plant equipment for 100-120 million pieces of bricks a year, such as facing bricks, pavers, hollow and thermal bricks.
2) Shale clay
3) Coal gangue
4) River silt
Hour output: 150m3/h
All technologies are from Bedeschi
http://www.zcrusher.com/jaw-crusher.html Application of Jaw
http://www.zcrusher.com/impact-crusher.html Impact crusher
http://www.zcrusher.com/ball-mill.html The ball mill is sui
http://www.zcrusher.com/rod-mill.html Rod mill introduction
http://www.zcrusher.com/rotary-dryer.html Drier(Drying Machi
http://www.zcrusher.com/rotary-kiln.html Rotary kiln introdu
http://www.zcrusher.com/flotation-machine.html This type of
http://www.zcrusher.com/composite-crusher.html Composite cru
http://www.zcrusher.com/Mobile-crusher.html Jaw Crusher and
http://www.zcrusher.com/hammer-crusher.html The hammer crush
http://www.zcrusher.com/double-roll-crusher.html Roll Crushe